Now Reading
DIY Embellished Paracord Bracelet

DIY Embellished Paracord Bracelet

Embellished Paracord Bracelet

With spring in the air, creativity is in full bloom, and we are loving it.

Soverynn features products independently selected by our editorial team. If a purchase occurs through the provided links, Soverynn may earn a commission.

There is something about the arrival of spring that encourages the urge to create, gather and share ideas. This DIY project, the Embellished Paracord Bracelet, is perfect for your next ‘Girls' Night In'. So, what are you waiting for? Set a date, invite your friends, gather the supplies and watch as creativity and memories bloom.

You'll Need

DIY Steps for Embellished Paracord Bracelet

Supplies for Embellished Paracord Bracelet

1

Begin by gathering all the supplies required to make an Embellished Paracord Bracelet. You may want to select and organize the jewels in a pattern that pairs well with your colored paracord.

measurement for paracord bracelet

2

Then measure your wrist by taking one end of the 10 ft. paracord and wrapping it loosely around your wrist 4x. For example, if your wrist is 6 inches, then you would need 24 inches of paracord. Take your scissors and cut your 4x measured wrist length from the 10 ft of paracord. You should now have two pieces of paracord.

Step 1: Embellished Paracord Bracelet

3

Next take the shorter paracord and tie the ends together with a knot as shown in the picture. Place the longer paracord centered and directly behind the knotted paracord.

Step 2: Embellished Paracord Bracelet

4

Now move the left rope across the two middle ropes and under the right rope. Take the right rope under the left and middle ropes and up through the left side of the loop.

Step 4: Embellished Paracord Bracelet

5

Slowly pull and tighten the left and right ropes and come to a knot. The knot should leave room for an approximate one-inch loop at the top of the bracelet. Then move the right rope over the two middle ropes and under the left rope.

Step 5: Embellished Paracord Bracelet

6

Take the left rope under the right rope and two middle ropes and up through the right side of the loop. Slowly pull and tighten the left and right ropes and come to a knot.

Step 6: Embellished Paracord Bracelet

7

Continue steps 4 through 6 until you reach the end of the paracord bracelet. Place the bracelet around your wrist to see how it fits. If you need to adjust the length of your paracord bracelet, be sure to do it now by moving the knot up or down. Then trim the four ends of the bracelet with scissors.

Step 7: Embellished Paracord Bracelet

8

To prevent the paracord from unraveling, take a lighter and burn the ends of the paracord to seal it. Now apply E6000 to the backside of the jewels and press each jewel firmly onto the paracord bracelet. Allow the jewels to dry overnight before wearing or gifting your embellished paracord bracelet.

Step 8: Embellished Paracord Bracelet

9

There are so many fun and creative ways to decorate your paracord bracelet. Be sure to share your DIY Embellish Paracord Bracelet design by tagging @Soverynn and #Soverynn.

© 2024 Soverynn | All Rights Reserved | Powered by Kinsta

Scroll To Top
Share This